Overview - Ignition System
WARNING: This page is about a different car, the 2017 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 8 Nm +90°.
- Replace after removing.
- The tightening specifications affect function of the knock sensor.
- Knock Sensor 1 -G61-
- Removing and Installing. Refer to Knock Sensor 1 -G61-, REMOVING AND INSTALLING .
- Spark Plug
- 30 Nm.
- Spark Plug Connectors
- Installation position. Refer to IGNITION COILS, REMOVING AND INSTALLING .
- Ignition Coil
- Ignition Coil 1 with Power Output Stage -N70-.
- Ignition Coil 2 with Power Output Stage -N127-.
- Ignition Coil 3 with Power Output Stage -N291-.
- Ignition Coil 4 with Power Output Stage -N292-.
- Removing and Installing. Refer to IGNITION COILS, REMOVING AND INSTALLING .
- Double Bolt
- In the existing threads: 9 Nm.
- In the new tapping threads: 10 Nm.
- Thread cutting.
- Nut
- 9 Nm.
- Bolt
- In the existing threads: 9 Nm.
- In the new tapping threads: 9 Nm.
- Thread cutting.
- Camshaft Position Sensor 3 -G300-
- Removing and Installing. Refer to Camshaft Position Sensor 3 -G300-, REMOVING AND INSTALLING .
- O-Ring
- Replace if damaged or leaking.
- O-Ring
- Replace if damaged or leaking.
- Camshaft Position Sensor -G40-
- Removing and Installing. Refer to Camshaft Position Sensor -G40-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm.
- O-Ring
- Replace if damaged or leaking.
- Engine Speed Sensor -G28-
- Removing and Installing. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Bolt
- 4 Nm +45°.
- Replace after removing.