Ignition Coils, Removing And Installing: Removing

WARNING: This page is about a different car, the 2017 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the nut -2-, free up the ground wire -1- and remove the double bolt -3- from underneath.

-- Disconnect the connectors and remove from the ignition coils at the same time -arrows-.

-- Insert the Puller: T10530 in the ignition coil opening -1-.

Fig 1: Identifying Puller T10530

Courtesy of AUDI OF AMERICA, LLC

-- Turn the knurled nut -2- clockwise -arrow- until the puller is clamped.

-- Remove the ignition coil carefully vertically -arrow- using the Puller: T10530 .

Fig 2: Identifying Puller T10530

Courtesy of AUDI OF AMERICA, LLC