Ignition Coils, Removing And Installing: Installing
WARNING: This page is about a different car, the 2017 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Insert the spark plug connector -2- by hand onto the ignition coil -1- all the way.
- The arrow markings on the spark plug connectors and on the ignition coil must point to each other as shown.
CAUTION:
Risk of destroying due to incorrect lubricant.
- Only use approved silicone paste.
-- Apply a thin bead of silicone paste around the sealing hose for the ignition -arrow-.
-- Push the ignition coils evenly onto the spark plugs using by hand (do not use any impact tools).
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .