Sun Visor, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi S3, 2017 Audi RS 3, 2017 Audi A3 Quattro, 2016 Audi S3, and 2016 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Unclip the sun visor mount expanding cap -1- -arrow- by sliding the Angled Screwdriver: VAS 6416 just approximately 1 mm under the cap.
NOTE:
If the Angled Screwdriver: VAS 6416 is inserted farther, it will be under the sun visor. It is then not possible to pry out the expanding cap.
-- Disengage the sun visor -2- at the center support.
-- Unclip the sun visor mount -1- with the clamp -2- downward -arrow- from the opening in the body and remove it.
-- Equipped on some models: disconnect the connector and remove the sun visor.