Fuel Level Sensor 2 - G169-, Removing And Installing: Installing
WARNING: This page is about a different car, the 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replace the seal.
Be careful not to bend the floater arm on the fuel level sensor when installing it.
Pay attention when connecting the connectors that they are secure.
-- Carefully insert the Fuel Level Sensor 2 -G169- into the fuel tank and clip it onto the suction jet pump.
-- Install the new locking flange seal -1-. The seal must be dry.
CAUTION:
Risk of leaking.
- When inserting sealing flange, sealing ring must not be damaged or crushed.
-- Bring the locking flange into the installation position.
- The tab -2- on the locking flange must face the hole -arrow- in the rocking ring and between the tabs -3 and 4- on the fuel tank.
-- Push the locking flange downward against the spring force.
-- Insert the locking ring and fasten using the Wrench - Fuel Sending Unit:T10202 .
Installation is performed in reverse order of removal, noting the following:
-- Install the rear bench seat. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .