Transmission Mount, Removing And Installing: Installing

Install in reverse order of removal. Note the following: 

• Replace the bolts that were tightened with an additional turn.

-- Secure the transmission support to the longitudinal member.

-- Lift the transmission using the engine support bridge spindle until the transmission support touches the support arm.

• The transmission support and the transmission support arm must be absolutely parallel to each other before installing the bolts.
• Push the rear of the transmission upward using a floor jack if necessary.

-- Tighten the subframe mount bolts.

-- Check the adjustment of the assembly mounts. Refer to SUBFRAME MOUNT, CHECKING ADJUSTMENT .

-- Remove the :10-222A  from the engine.