SUBFRAME Mount, Checking Adjustment: Procedure

The following dimensions must be attained:

• The clearance between the engine support -2- and the engine mount -1- must be at least -a- = 10 mm.

  Courtesy of AUDI OF AMERICA, LLC

• The casting edge on the engine support must be parallel to the support arm.
• Dimension -b- = Dimension -b-.
• Distance of at least -a- = 10 mm can also be checked with corresponding round stock.

-- If the distance measured is too small or too large, adjust the subframe. Refer to SUBFRAME MOUNT, ADJUSTING .