Part II
Part I. Refer to Part I .
- Cylinder Head
- Do not rework the upper sealing surface
- Only replace the cylinder head and cylinder head cover together
- O-Ring
- Check for damage
- Not available separately, included in the delivery package -item : Cam Adjustment Actuator
- Coat with engine oil
- Cam Adjustment Actuator
- Cam Adjustment Actuator 1 -F366-
- Cam Adjustment Actuator 2 -F367-
- Cam Adjustment Actuator 3 -F368-
- Cam Adjustment Actuator 4 -F369-
- Cam Adjustment Actuator 5 -F370-
- Cam Adjustment Actuator 6 -F371-
- Cam Adjustment Actuator 7 -F372-
- Cam Adjustment Actuator 8 -F373-
- Removing and Installing. Refer to CAM ADJUSTMENT ACTUATOR, REMOVING AND INSTALLING .
- Bring into the installation position. Refer to Installing - The cam adjustment actuator pin must be brought into the installation position. .
- Bolt
- 5 Nm
- Ball Pin
- In the existing threads: 9 Nm
- In the new tapping threads: 11 Nm
- For the engine cover
- Thread cutting
- O-Ring
- Replace if damaged
- Coat with engine oil
- Plugs
- O-Ring
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Roller Rocker Lever
- Removing and Installing. Refer to CAMSHAFT, REMOVING AND INSTALLING .
- Mark the installed position for reinstallation.
- Check the roller bearing for ease of movement
- Lubricate the running surfaces before installing
- Installation position and allocation. Refer to Figure.
- Bolt
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Oil Separator
- Removing and Installing. Refer to OIL SEPARATOR, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Seal
- Replace after removing
- Vacuum Pump
- Overview. Refer to OVERVIEW - VACUUM PUMP .
- Bolt
- Tightening specification. Refer to OVERVIEW - VACUUM PUMP .
- Seal
- Replace if damaged
- O-Ring
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Camshaft Position Sensor -G40-
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolt
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolt
- In the existing threads: 9 Nm
- In the new tapping threads: 11 Nm
- Thread cutting
- Bracket
- For the EVAP Canister Purge Regulator Valve 1 -N80-