Part II
Part I. Refer to Part I .
- Cylinder Head
- Do not rework the upper sealing surface
- Only replace the cylinder head and cylinder head cover together
- Ball Pin
- In the existing threads: 9 Nm
- In the new tapping threads: 11 Nm
- Thread cutting
- For the engine cover
- O-Ring
- Replace after removing
- Coat with engine oil
- Plugs
- Oil Separator
- Removing and Installing. Refer to OIL SEPARATOR, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Seal
- Replace after removing
- Vacuum Pump
- Overview. Refer to OVERVIEW - VACUUM PUMP .
- Bolt
- Tightening specification. Refer to OVERVIEW - VACUUM PUMP .
- Seal
- Replace if damaged
- O-Ring
- Replace after removing
- Coat with engine oil
- Camshaft Position Sensor -G40-
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolt
- Tightening specification -item 13- : Bolt .
- Bolts
- In the existing threads: 9 Nm
- In the new tapping threads: 11 Nm
- Thread cutting
- Bracket
- For the EVAP Canister Purge Regulator Valve 1 -N80-