NOx SENSOR 2 -G687-, REMOVING AND INSTALLING: Removing

• Follow the safety precautions when working on the exhaust system. Refer to SAFETY PRECAUTIONS WHEN WORKING ON EXHAUST SYSTEM .

-- Remove the left center underbody trim panel. Refer to OVERVIEW - UNDERBODY TRIM PANELS / UNDERBODY TRIM PANELS, REMOVING AND INSTALLING .

Fig 1: Identifying Rear Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

Fig 2: NOx Sensor Control Module 2 -J881- (Country-Specific)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrows-.

-- Free up and remove the NOx Sensor Control Module -J583-.

-- Remove the NOx Sensor 2 -G687- -arrow-.

Fig 3: NOx Sensor 2 -G687- (Country-Specific) - Tightening Specification

Courtesy of AUDI OF AMERICA, LLC