Reducing Agent Injector -N474-, Removing And Installing: Installing
Install In Reverse Order Of Removal.Note The Following:
Replace the seal.
- Installed position: The tabs in the Reducing Agent Injector -N474- -2- must fit into the mounts in the exhaust pipe -1- -arrows-.
- Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts information.
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
Adapt the adaptation value for the SCR system after draining reducing agent or replacing components. Use the Vehicle Diagnostic Tester.
- Select 01 - On Board Diagnostic (OBD) Capable Systems
- 01 - Engine Electronics
- 01 - Engine Electronics, Functions
- 01- Adaptation Value - Reducing Agent System, Reseting