Rear Muffler, Removing And Installing, Vehicles With Front Wheel Drive And Torsion Beam Axle: Installing

Install In Reverse Order Of Removal. Note The Following: 

• Replace the seal.

-- Pay attention to the installation position:

• Refer to INSTALLED LOCATION OF THE FRONT EXHAUST PIPE SCREW CLAMP 
• Refer to INSTALLED LOCATION OF THE SEAL BETWEEN THE EMISSIONS CONTROL MODULE AND FRONT EXHAUST PIPE. .
• Refer to INSTALLED POSITION OF FRONT CLAMPING SLEEVE .
• Refer to INSTALLED POSITION OF REAR CLAMPING SLEEVE .

-- Refer to EXHAUST SYSTEM, INSTALLING AND ALIGNING .