EGR Cooler, Removing And Installing: Installing

Install In Reverse Order Of Removal. Note The Following: 

-- Replace the seal and hose clamps.

-- Install the hose -2- on the EGR cooler -1-.

Courtesy of AUDI OF AMERICA, LLC

• Installed Position: The marking "EGR side" -arrow- points to the EGR cooler.

-- Pay attention that the air duct hose sits free of tension.

-- Install the EGR cooler -1- with the seal and clamp on the emissions control module.

Courtesy of AUDI OF AMERICA, LLC

-- Turn the EGR cooler counterclockwise -arrow- and at the same time insert the hose -3- for the turbocharger -2-.

-- Move the screw-type clamp -3- in its installation position.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the threaded connections in the specified sequence. Refer to EGR COOLER - TIGHTENING SPECIFICATION AND SEQUENCE .

-- Install the left coolant pipes. Refer to LEFT COOLANT PIPES, REMOVING AND INSTALLING .

-- Install and adjust the selector lever cable. Refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING / SELECTOR LEVER CABLE, CHECKING AND ADJUSTING / OVERVIEW - SELECTOR MECHANISM /OVERVIEW - SELECTOR MECHANISM .