Catalytic Converter, Removing And Installing: Installing: Notes

• Replace the self-locking nuts and bolts, gaskets, seals and O-rings after removing.
• Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts information.
• During installation, install all cable ties back at the same position.

-- Place new seals on the entrance funnel centering pins on the catalytic converter, push the new clamp on the entrance funnel.

-- Install the catalytic converter from above, and place the stud bolts in the lower bracket.

-- Further tightening sequence is in the following table. Refer to CATALYTIC CONVERTER TIGHTENING SPECIFICATION AND SEQUENCE .