Overview - Instrument Panel CROSSMEMBER
- Steering Column
- Removing and installing. Refer to STEERING COLUMN, REMOVING AND INSTALLING .
- Bolt
- Quantity: 3
- Tightening specification. Refer to OVERVIEW - RELAY CARRIERS, FUSE PANELS AND E-BOXES .
- Bolt
- Only driver side
- 20 NmCAUTION:
There is a risk of malfunctions do to a faulty ground connection.
- The counter threaded and contact surface must be free of paint, coating, and corrosion, the threaded connection serves as the ground connection for the knee airbag.
- Nut
- Quantity: 2
- Always replace after removing
- 20 NmCAUTION:
There is a risk of malfunctions do to a faulty ground connection.
- The contact surface must be free of paint, coating, and corrosion, the threaded connection serves as the ground connection for the knee airbag.
- Threaded Pin
- Quantity: 2
- 20 Nm
- Bolt
- 20 Nm
- Crash Bolster
- Removing and Installing. Refer to CRASH BOLSTER, REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- Bracket for Vehicle Electrical System Control Module
- Overview. Refer to OVERVIEW - RELAY CARRIERS, FUSE PANELS AND E-BOXES .
- Control Module Bracket
- Installed depending on the version
- Bracket
- For Access/Start Authorization Control Module -J518-
- Overview. Refer to OVERVIEW - ACCESS/START AUTHORIZATION SYSTEM .
- Instrument Panel Crossmember
- Removing and Installing. Refer to INSTRUMENT PANEL CROSSMEMBER, REMOVING AND INSTALLING .
- Bolt
- 4 Nm
- Support for Instrument Panel
- Quantity: 2
- Removing and Installing. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Bolts
- 4 Nm
- Bolt
- Quantity: 2
- 20 Nm
- Bolt
- Quantity: 4
- Tightening Specification. Refer to OVERVIEW - STEERING COLUMN .