Stop And Adjusting Buffer, Removing And Installing:

-- After installing the rear lid trim panel push in the inner stop piece

-- For installing the rear lid trim panel the inner stop piece must be installed.

-- After installing the rear lid trim panel push in the outer stop piece until it engages.

• Install after adjusting the rear lid via the striker. Refer to HEIGHT ADJUSTMENT AT STRIKER .

  -- Adjust the buffer with hex socket wrench 5 mm.

  -- With the rear lid closed a piece of paper must be able to just fit between the adjusting buffer and the body surface.

-- Adjust the front side flush via the rear lid hinge. Refer to SIDE, LENGTH AND HEIGHT ADJUSTMENT AT HINGE .

-- Adjust the rear side flush via the striker.

-- Push in the rear lid before installing the rear lid trim.