LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> A3 TDI Prestige >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Hood, Lids -- (A3 Sedan) >> 55 Hood, Lids >> Hood >> Gas-Filled Strut, Removing And Installing. >> Notes

Gas-Filled Strut, Removing And Installing.: Notes

GWWA55-10871Courtesy of AUDI OF AMERICA, LLC
  1. Hood
  2. Gas-Filled Strut
    • Lift the locking spring slightly and pull the gas-filled strut off the ball pin.
      • Ensure correct positioning during installation: The gas-filled strut tube must be attached on the body-side.
  3. Ball Pin
  4. Ball Pin
scientia non olet · About LEMON Manuals