Overview - Front Backrest, Backrest Adjustment Motor
NOTE:
The Cushion And Cover Are Not Shown In The Illustration.
- Adjustment Shaft
- The threaded hole for the nut -8- must be cleaned, for example, with a thread tap.
- Coat the threads on the adjustment shaft with locking fluid before installing the nut.
- Driver Backrest Adjustment Motor -V45-
- Front passenger side: Front Passenger Backrest Adjustment Motor -V46-
- Removing and Installing. Refer to DRIVER BACKREST ADJUSTMENT MOTOR -V45- /FRONT PASSENGER BACKREST ADJUSTMENT MOTOR -V46-, REMOVING AND INSTALLING .
- Rivet
- Quantity: 2
- Bracket
- Bolt
- 7.5 Nm
- Replace after removing.
- Clean the threaded hole for the bolt with a thread tap, for example
- Use locking fluid when installing the bolt. Refer to the Parts Information for the locking fluid.
- Backrest Frame
- Washer
- Nut
- 8 Nm
- Replace after removing.