Checking And Adjusting
-- Push the lever -1- on the backrest hinge until stop in the direction of the -arrow-.
The cushion and cover are not shown in the illustration.
-- Release the release cable adjuster by holding the upper section -1- with pliers and turning the securing sleeve -2- approximately 45° in the direction of -arrow A-.
-- Press the securing sleeve all the way down as far as the stop to release it -arrow B-.
- The lower section -3- must be able to rotate.
-- To adjust, turn the upper and lower sections in opposite directions.
-- Adjust the release cable so that the release late -1- on the tunnel-side seat rail -3- just begins to raise.
-- Check The Adjustment With A Feeler Gauge:
- The 0.1 mm feeler must slide through all ends -arrows- of the release plate.
- The 0.3 mm feeler does not have to slide through a maximum of one end.
-- After adjusting the release cables perform a functionality test.
-- If it does not release or only releases partially, check the release cable routing or repeat adjustment.
-- Re-engage the release cable adjuster.