Additional Work After Replacing All Wheel Drive Control Module -J492-
NOTE:
Only perform the additional work only if the All Wheel Drive Control Module -J492- was replaced.
-- Connect the Vehicle Diagnostic Tester and turn on the ignition.
-- Select the function 22 - All Wheel Drive Electronics in the Vehicle Diagnostic Tester under Guided Functions in the directory 22- Replacing Control Module .
- Follow all the instructions given by the Vehicle Diagnostic Tester exactly.
With the Vehicle Diagnostic Tester the installed rear final drive "adapts" on the All Wheel Drive Control Module -J492-.
NOTE:
A system check will take place when the 22 - Control Module Replacing function is complete. If malfunctions appear, then use "Guided Fault Finding" to correct them.