LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2015 >> S8 >> Repair and Diagnosis >> External Pages >> Different car >> Section 696 (Heating, Ventilation & Air Conditioning (2 Of 2) (As Of 06.2014)) >> 87 Air Conditioning >> Battery Cooling Module >> Temperature Sensor after Hybrid Battery Evaporator -G757-, REMOVING AND INSTALLING >> Installing

Temperature Sensor after Hybrid Battery Evaporator -G757-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Installation is carried out in the reverse order while observing the following.

-- Install the remaining removed components.

-- Check that the current seals are not damaged and in their correct positions.

-- Turn on the ignition.

-- After installing, check the DTC memory for the Climatronic Control Module -J255- display and control head and the Battery Regulation Control Module -J840- and, if necessary, erase the displayed faults using the Vehicle Diagnostic Tester in the "Guided Fault Finding  " function.

scientia non olet · About LEMON Manuals