Overview - Cylinder Block, Transmission Side: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2014 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Cylinder Block, Transmission Side

Courtesy of AUDI OF AMERICA, LLC

Cylinder Block
Alignment Sleeves
Transmission Side Sealing Flange
- With gasket
- Always replace after removing
- Do not apply oil to the seal.
- Before installing, remove oil residue from crankshaft journal with a clean cloth
- Removing and Installing. Refer to TRANSMISSION SIDE SEALING FLANGE, REMOVING AND INSTALLING, OIL SIDE SEALING LIP .
Bolt
- Tightening Specifications and Sequence
  - With 6 bolts. Refer to Figure .
  - With 8 bolts. Refer to Figure .
Drive Plate
- Removing and installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING
- Equipment versions with a manual transmission must have a needle bearing inside the drive plate; if necessary install the needle bearing. Refer to NEEDLE BEARING IN DRIVE PLATE, REPLACING .
- For equipment version with a dual-clutch transmission/automatic transmission, then do not install a needle bearing inside the crankshaft. Remove the needle bearing if necessary. Refer to NEEDLE BEARING IN DRIVE PLATE, REPLACING .
Bolt
- 60 Nm + 90°
- Always replace after removing
Needle Bearing
- Equipment version with manual transmission
- Replacing. Refer to NEEDLE BEARING IN DRIVE PLATE, REPLACING .
Intermediate Plate
- Installing. Refer to Figure .