Crankshaft Seal, Replacing, Transmission Side

Special Tools And Workshop Equipment Required

Procedure

Fig 1: Prying Out Sealing Ring Using Extractor Lever T20143/2

Courtesy of AUDI OF AMERICA, LLC

-- Remove the drive plate, refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Pry out the shaft seal using puller T20143/2.

-- Clean the running and sealing surface.

-- Place the assembly device T10122/1 on the pull sleeve T10122/2 and slide the shaft seal -A- onto the pull sleeve.

Fig 2: Identifying Seal, Sleeve T10122/1 And Assembly Tool T10122/2

Courtesy of AUDI OF AMERICA, LLC

-- Remove the assembly device.

-- Position the pull sleeve T10122/2 with shaft seal -1- on the crankshaft.

Fig 3: Identifying Pull Sleeve T10122/2 With Sealing Ring On Crankshaft

Courtesy of AUDI OF AMERICA, LLC

-- Install the shaft seal in evenly all around with thrust piece T10122/3 until flush.

Fig 4: Pressing In Seal Evenly All Around Until It Reaches Stop Using T10122/3

Courtesy of AUDI OF AMERICA, LLC

-- Install the drive plate, refer to DRIVE PLATE, REMOVING AND INSTALLING .