All Wheel Drive Pump -V415-, REMOVING AND INSTALLING: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2018 Audi A7 Quattro, 2017 Audi S7, and 2017 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- The hydraulic pump -A- is installed inside the hydraulic control unit. Assembling the hydraulic pump. Refer to 23.
- The adapter -B- is installed in the recesses in the hydraulic pump.
- A new O-ring -D- is on the All Wheel Drive Pump -V415-.
-- Install the All Wheel Drive Pump -V415- with the coupling -C- in the adapter -B-.
-- Diagonally tighten the four bolts on the All Wheel Drive Pump -V415- -2- to the tightening specification -item 1- HYDRAULIC CONTROL UNIT, DISASSEMBLING AND ASSEMBLING.
-- Connect the connector -1- to the All Wheel Drive Pump -V415-.
-- Fill with ATF in the rear final drive. Refer to ATF ON REAR FINAL DRIVE 0BF AND 0BE, FILLING .