Gear Oil Level In Rear Final Drive 0BF And 0BE, Checking
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2018 Audi A7 Quattro, 2017 Audi S7, and 2017 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Test Requirement
- Gear oil temperature: 10 °C to 60 °C (50 °F to (140 °F)
- The rear final drive must be in the installed position.
- The vehicle must be level.
- Overview of the gear oil sealing plugs. Refer to OVERVIEW - DRAIN AND INSPECTION PLUG FOR ATF AND GEAR OIL, REAR FINAL DRIVE 0BF AND 0BE
Special tools and workshop equipment required
- Drip Tray
Rear Final Drive 0BF
-- Remove the gear oil check plug -arrow-, located on the right side of the final drive.
Rear Final Drive 0BE
-- Remove the gear oil check plug -1-.
Continuation for All Rear Final Drives
- The oil level is correct when the rear final drive is filled up to the lower edge of the oil fill hole.
-- If necessary fill the gear oil.
- Refer to GEAR OIL IN REAR FINAL DRIVE 0BF, FILLING
- Refer to GEAR OIL IN REAR FINAL DRIVE 0BE, FILLING
-- Install the gear oil inspection plug -arrow- and tighten. Tightening specification -item 22- OVERVIEW - REAR FINAL DRIVE