All Wheel Drive Control Module -J492-, REMOVING AND INSTALLING
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2018 Audi A7 Quattro, 2017 Audi S7, and 2017 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
All Wheel Drive Control Module -J492- component location -item 1- ELECTRICAL/ELECTRONIC COMPONENTS AND COMPONENT LOCATIONS.
Removing and installing is on the A4 Sedan.
- The ignition is off.
-- Remove the luggage compartment floor covering.
-- Remove the covering and the vehicle tools mount.
-- Remove the All Wheel Drive Control Module -J492- -A- from the bracket -C-.
-- Disconnect the connector -B- from the All Wheel Drive Control Module -J492-.
-- Install the All Wheel Drive Control Module -J492- in reverse order of removal.
- If the All Wheel Drive Control Module -J492- was replaced then additional work is necessary. Refer to All Wheel Drive Control Module -J492-, ADDITIONAL WORK AFTER REPLACING .