LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2015 >> S7 >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Rear Final Drive 0BC, 0BD, 0BE & 0BF) >> 39 Final Drive, Differential >> Removal And Installation >> Left Seal, Replacing >> Left Seal, Replacing, 0BE, 0BF >> Removing

Left Seal, Replacing, 0BE, 0BF: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- General Repair Instructions. Refer to REPAIR INFORMATION .

-- Remove the rear final drive. Refer to FINAL DRIVE .

-- Remove the flange shaft bolt. To do this, install two bolts into the flange and counterhold the flange shaft using an assembly lever.

Fig 1: Identifying Flange Shaft Bolt, Removal
GWWA39-10380Courtesy of AUDI OF AMERICA, LLC

-- Remove flange shaft.

NOTE:

If it not possible to remove the flange shaft by hand, then use Slide Hammer-Complete Set VW 771 to remove it.

-- Remove the flange shaft seal using Slide Hammer-Complete Set VW 771 and Additional Part for VW 771VW 771/37.

Fig 2: Identifying Flange Shaft Seal, Removal
GWWA39-10381Courtesy of AUDI OF AMERICA, LLC