Clutch End Cover Without Bushing:
-- Place the :T10302 on a level surface.
-- To pre-form the inner seal on the new clutch end cover, guide the clutch end cover with the outer side facing downward evenly and horizontally over the :T10302 .
-- Remove the :T10302 upward out of the clutch end cover.
-- Place the :T10302 on the end of the dual clutch shaft.
Risk of Leaks on the Clutch End Cover.
Transmission Damage Due to Oil Loss.
- Do not touch the seal in the inner opening of the clutch end cover!
- Do not load the clutch end cover by hitting with a hammer.
-- Guide the clutch end cover with the outer side facing upward horizontally over the :T10302 and press it evenly into its seat.
-- If necessary, carefully pry the clutch end cover into its seat with a screwdriver -arrow- as shown until the shaft ring can be installed.
-- Install the clutch end cover shaft ring in the transmission housing by counterholding the shaft ring on the opposite side so that it stays in its groove.
-- Using a screwdriver, make sure the shaft ring is completely engaged.
-- Remove the :T10302 .