Clutch End Cover With Bushing (Assembly Aid):
-- Insert the clutch end cover with the bushing.
Risk of Leaks on the Clutch End Cover.
Transmission Damage Due to Oil Loss.
- Do not touch the seal in the inner opening of the clutch end cover!
- Do not load the clutch end cover by hitting with a hammer.
-- Push the clutch end cover evenly into its seat.
-- If necessary, carefully pry the clutch end cover into its seat with a screwdriver -arrow- as shown until the shaft ring can be installed.
-- Install the clutch end cover shaft ring in the transmission housing by counterholding the shaft ring on the opposite side so that it stays in its groove.
-- Using a screwdriver, make sure the shaft ring is completely engaged.
-- Remove the bushing (assembly aid).
Continuation for Both Clutch End Covers:
-- Fill the transmission fluid for the dual clutch transmission after installing it. Refer to TRANSMISSION FLUID, DRAINING AND FILLING .
-- Perform the basic setting using the Vehicle Diagnostic Tester in Guided Functions .