LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2015 >> S3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (CYLINDER HEAD, VALVETRAIN (4-Cylinder 2.0L 4V TFSI) -- (A3)) >> 15 Cylinder Head, VALVETRAIN >> Chain Drive >> Overview - Camshaft Timing Chains >> Overview - Camshaft Timing Chain, Engine With Two Camshaft Adjusters >> Bearing Bracket Tightening Specifications And Sequence

Bearing Bracket Tightening Specifications And Sequence

WARNING: This page is about a different car, the 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Bearing Bracket - Assembly Instructions
GWWN15-11326Courtesy of AUDI OF AMERICA, LLC

If a new bearing bracket -3- with adapter sleeve -4- should be installed, it must be checked before installing the bearing bracket in the hole -arrow- in the cylinder head -1-.

If the hole -arrow- is not designed for using the adapter sleeve -4- the adapter sleeve must be removed from the bearing bracket. For this hole the short bolt -2- should be used. Refer to the parts information for the correct bolt.

Fig 2: Bearing Bracket - Tightening Sequence
GWWA15-11797Courtesy of AUDI OF AMERICA, LLC

-- Tighten The Bolts In The Steps Shown In The Sequence:

scientia non olet · About LEMON Manuals