Balance Shaft Gasket, Replacing, Intake Side

Special tools and workshop equipment required 

• Seal Installer, Intermediate Shaft :T10356/1 

Procedure 

-- Remove the coolant pump toothed belt. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .

• Pay attention to the direction or rotation: the bolts for the drive wheel have left-hand threads - there is a risk of damaging the threads.

  Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- and then remove the drive wheel -1- for the coolant pump toothed belt.

-- Firmly press a screwdriver -1- on the surface of the sealing ring -2- in direction of -arrow B-.

Courtesy of AUDI OF AMERICA, LLC

-- Pry out the sealing ring -arrow A- in direction of.

-- Clean the contact and sealing surface.

-- Coat the sealing surface of the balance shaft -2- with transmission fluid.

Courtesy of AUDI OF AMERICA, LLC

-- Push the sealing ring -1- onto the balance shaft.

• The labeling "Inside" -arrow- must point to the engine.

• Pay attention to the direction or rotation: the bolts for the drive wheel have left-hand threads - there is a risk of damaging the threads.

  Courtesy of AUDI OF AMERICA, LLC

-- Mount the :T10353/1  on the seal -1- and then tighten it carefully all the way into the cylinder block with the bolt -2-. Be careful not to tilt the seal when doing this.

-- Install the coolant pump toothed belt. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .