LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2015 >> S3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (CYLINDER HEAD, VALVETRAIN (4-Cylinder TDI Common Rail 1.6L; 2.0L 4V Engine) -- (A3 SEDAN)) >> 15 Cylinder Head, VALVETRAIN >> VALVETRAIN >> Valve Shaft Seals, Removing And Installing >> Valve Shaft Seals, Removing And Installing, Cylinder Installed >> Procedure

Valve Shaft Seals, Removing And Installing, Cylinder Installed: Procedure

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove all glow plugs. Refer to GLOW PLUG, REMOVING AND INSTALLING .

-- Remove the camshaft housing. Refer to CAMSHAFT HOUSING, REMOVING AND INSTALLING .

-- Mark the allocation of the roller rocker lever and the hydraulic adjusting elements so they can be installed again.

-- If necessary, remove the roller rocker levers with the hydraulic adjusting elements and place them on a clean surface.

-- Move piston for that cylinder to "Bottom Dead Center (BDC) position".

scientia non olet · About LEMON Manuals