LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2015 >> S3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (CRANKSHAFT, CYLINDER BLOCK (4-Cylinder TDI Common Rail 1.6L; 2.0L 4V Engine) -- (A3 SEDAN)) >> 13 Crankshaft, Cylinder Block >> Piston And Connecting Rod >> Connecting Rods, Checking Radial Clearance >> Procedure

Connecting Rods, Checking Radial Clearance: Procedure

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the connecting rod bearing cap. Clean the bearing cap and journal.

-- Place the Plastigauge® over the entire width of the bearing journal or into the bearing shells.

-- Place connecting rod bearing cap and fasten with the old bolts (refer to -item 1-  OVERVIEW - PISTONS AND CONNECTING RODS- List Item:Bolts), do not turn the crankshaft.

-- Install the connecting rod bearing cap.

-- Compare width of Plastigauge® with calibrated scale.

Radial clearance: 

-- Replace connecting rod bolts.

scientia non olet · About LEMON Manuals