Transmission Mount, Removing And Installing: Removing

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the battery tray -1-. Refer to BATTERY .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Engine Control Module -J623- from the bracket. Refer to Engine Control Module -J623-, REMOVING AND INSTALLING .

Courtesy of AUDI OF AMERICA, LLC

-- Expose the vacuum hoses -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the clamp -1- and remove the air guide pipe.

-- Remove the bolts -arrows- and remove the bracket -1-.

Courtesy of AUDI OF AMERICA, LLC

• Depending on the version different brackets are installed.

-- Unclip the wiring guide -1- upward and move it slightly to the side in direction of -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -arrow- and remove the ground wire.

Courtesy of AUDI OF AMERICA, LLC

• The illustration shows a vehicle with dual-clutch transmission 0CW.

-- Remove windshield wiper arms. Refer to WINDSHIELD WIPER SYSTEM .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the plenum chamber cover. Refer to BULKHEAD .

Courtesy of AUDI OF AMERICA, LLC

-- Remove caps above the front suspension strut bolted connections.

Courtesy of AUDI OF AMERICA, LLC

-- Place the :10-222A/31-2  on the suspension strut mounts.

• The ribs -arrow- faces the direction of travel.

-- Position the :10-222A/4  with :T40091/3  as shown in the illustration.

-- Install the additional tools on the left in the engine compartment as illustrated.

Courtesy of AUDI OF AMERICA, LLC

-- Attach the left :10-222A/11  carabiner hook to the engine lifting eye -arrow-.

-- Slightly pretension the engine/transmission assembly with the spindle, do not lift.

-- Remove the bolts -arrows- and the transmission mount -1-.

Courtesy of AUDI OF AMERICA, LLC

• The illustration shows a vehicle with a manual transmission 02Q.