Front Sensor, Removing And Installing: Removing
WARNING: This page is about a different car, the 2017 Audi A3, 2016 Audi A3, and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Loosen the lower front wheel housing liner in the area of the bumper and push aside. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .
-- Press both tabs in direction of -arrows- to the side and press the sensor -1- inward from the outside.
-- Disconnect the connector -2- by sliding the retainer -3- back and pressing the release down.