Crankshaft Seal, Replacing, Transmission Side
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Crankshaft Seal Installer Kit :T10122B
- Seal Installer - Crankshaft :T10122/1
- Seal Installer - Crankshaft - Pull Sleeve :T10122/2
- Seal Installer - Crankshaft - Thrust Piece :T10122/3
- Puller - Crankshaft/Power Steering Seal :T20143/2
- Transmission removed.
-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
-- Pry out the shaft seal using :T20143/2 .
-- Clean the running and sealing surface.
-- Place the :T10122/1 on the :T10122/2 and slide the shaft seal -A- onto the pull sleeve.
-- Remove the assembly device.
-- Position the pull sleeve :T10122/2 with shaft seal -1- on the crankshaft.
-- Install the shaft seal in evenly all around with :T10122/3 until flush.
-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .