LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2015 >> RS 7 >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Engine System (Cylinder Head & VALVETRAIN - Service Information - 4.0L - CEUC, CRDB, CTGE, CWUB, CWUC)) >> Cylinder Head, VALVETRAIN >> VALVETRAIN >> Overview - VALVETRAIN >> Tightening Specifications

Tightening Specifications

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
GWWA15-12254
NOTE:

Replace the bolts that were tightened with an additional turn.

-- Tighten the bolts in steps in the sequence shown:

Step Bolts Tightening Specification/Additional Turn
1. -1 to 21- Install all the way in by hand.
  • The camshaft housing contact surface must lay entirely on top of the cylinder head
2. -1 to 21- 8 Nm
3. -1 to 21- Tighten an additional 90°
scientia non olet · About LEMON Manuals