Camshaft Adjustment Valve 2 -N208- / Exhaust Camshaft Adjustment Valve 2 -N319-, REMOVING AND INSTALLING, CYLINDER BANK 2 (LEFT): Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
WARNING:
Fire hazards and risk of damage for a faulty engine cover.
- The engine cover must be always be installed before the hood is closed.
- The engine may neither be started nor driven without an engine cover.
-- Open the clamps -1 and 4- and remove the coolant hoses.
-- Free up the coolant hose -arrow-.
-- Disconnect the connector -2-.
-- Remove the bolt -3-.
-- Remove the coolant reservoir upward from the mount and move it towards the front.
-- Remove the connectors -1- from the bracket -2- disconnect them, and then free up the wires.
-- Unclip the mount upward.
-- Remove the bolt -1- and the double bolt -3- and then press the wiring guide -2- slightly forward.
-- Disconnect the connectors -2-.
-- Press the electrical wiring harness to the side.
-- Remove the affected bolt -1- and then remove the valve.