Overview - Right Camshaft Timing Chain
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2017 Audi S7, 2017 Audi RS 7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 80 Nm + 90°
- Always replace
- With driver for vacuum pump
- Camshaft Adjuster
- For the intake camshaft
- Designation "IN"
- Removing and installing. Refer to CAMSHAFT TIMING CHAIN, REMOVING FROM CAMSHAFTS .
- Bolt
- 80 Nm + 90°
- Always replace
- Camshaft Adjuster
- For the exhaust camshaft
- Designation "EX"
- Removing and installing. Refer to CAMSHAFT TIMING CHAIN, REMOVING FROM CAMSHAFTS .
- Bolt
- 20 Nm + 45°
- Always replace
- Mounting Pin
- For the right camshaft timing chain drive sprocket
- Asymmetrical version
- Installed position. Refer to 12
- Drive Chain Sprocket
- For the right camshaft timing chain
- Installed position. Refer to 12
- Right Camshaft Timing Chain
- Mark the running direction with paint for reinstallation
- Removing from the camshafts. Refer to CAMSHAFT TIMING CHAIN, REMOVING FROM CAMSHAFTS .
- Removing and installing. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .
- Thrust Washer
- For the right camshaft timing chain drive sprocket
- Asymmetrical version
- Installed position. Refer to 12
- Chain Tensioner
- For the right camshaft timing chain
- Removing and installing. Refer to CAMSHAFT TIMING CHAIN TENSIONER, REMOVING AND INSTALLING .
- Glide
- Bolt
- 5 Nm + 90°
- Always replace
- The alignment bushings in the right camshaft timing chain drive sprocket mounting pins -3- must engage in the holes in the thrust washer -1- and cylinder block.
2 - Right Camshaft Timing Chain Drive Sprocket
4 - Bolt