Overview - Bumper Cover, Audi RS 7

Fig 1: Identifying Bumper Cover Overview - Audi RS 7

Courtesy of AUDI OF AMERICA, LLC

Rear Bumper Cover
- Removing and installing. Refer to BUMPER COVER, REMOVING AND INSTALLING, VEHICLES THROUGH MY 2014 .
Bolt
- 2 Nm
Mount
- For the tail pipe trim
- Removing and installing. Refer to TAIL PIPE TRIM MOUNT, REMOVING AND INSTALLING, AUDI RS7 .
Tail Pipe Trim
- Removing and installing. Refer to TAIL PIPE TRIM, REMOVING AND INSTALLING, AUDI RS7 .
Bolt
- 2 Nm
- Quantity: 4
Bolt
- Quantity: 3
- Tightening sequence. Refer to Figure
Side Mount
- For the bumper cover
- Removing and installing. Refer to BUMPER COVER SIDE MOUNT, REMOVING AND INSTALLING .
Upper Mount
- For the bumper cover
- Removing and installing. Refer to UPPER BUMPER COVER MOUNT, REMOVING AND INSTALLING .
Bolt
- Quantity: 3
- Tightening sequence. Refer to Figure
Locking Rail
- For the bumper cover
Lane Change Assistance Control Module
- Removing and installing. Refer to LANE CHANGE ASSISTANCE CONTROL MODULES -J769- / -J770- .
Screw
- 2 Nm
- Quantity: 3
Center Mount
- For the bumper cover
- Removing and installing. Refer to CENTER BUMPER COVER MOUNT, REMOVING AND INSTALLING .
Nut
- Quantity: 2
- Tightening sequence. Refer to Figure
Bumper Cover Trim
- Removing and installing. Refer to BUMPER COVER TRIM, REMOVING AND INSTALLING .
Nut
- 2 Nm
- Quantity: 4
Cover
- For the towing eye
Bumper Cover Lower Section
- There are different versions.
- Removing and installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING, AUDI RS7 .
Bolt
- 1.7 Nm
- Vehicles without a trailer hitch, quantity: 3
- Vehicles with a trailer hitch, quantity: 2