Overview - Bumper Cover, Audi A7/S7 Through MY 2014
CAUTION:
If the vehicle has lane change assistance, the lane change assistance control module -J769- / -J770- must be recalibrated. Refer to LANE CHANGE ASSISTANCE CONTROL MODULES -J769- / -J770-, CALIBRATING
.
- Bumper Cover Lower Section
- There are different versions.
- Removing and installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING, AUDI A7/S7 .
- Rear Bumper Cover
- Removing and installing. Refer to BUMPER COVER, REMOVING AND INSTALLING, VEHICLES THROUGH MY 2014 .
- Bolt
- 2 Nm
- Bolt
- Quantity: 3
- Tightening sequence, refer to Fig 4
- Side Mount
- For the bumper cover
- Removing and installing. Refer to BUMPER COVER SIDE MOUNT, REMOVING AND INSTALLING .
- Rear Parking Aid Sensor
- Removing and installing. Refer to REAR PARKING AID SENSORS -G203- / -G204- / -G205- / -G206- .
- Locking Rail
- For the bumper cover
- Upper Mount
- For the bumper cover
- Removing and installing. Refer to UPPER BUMPER COVER MOUNT, REMOVING AND INSTALLING .
- Bolt
- Quantity: 3
- Tightening sequence, refer to Fig 2
- Lane Change Assistance Control Module
- Removing and installing. Refer to LANE CHANGE ASSISTANCE CONTROL MODULES -J769- / -J770- .
- Rear Parking Aid Sensor
- Removing and installing. Refer to REAR PARKING AID SENSORS -G203- / -G204- / -G205- / -G206- .
- Center Mount
- For the bumper cover
- Removing and installing. Refer to CENTER BUMPER COVER MOUNT, REMOVING AND INSTALLING .
- Nut
- Quantity: 2
- Tightening sequence, refer to Fig 3
- Bumper Cover Trim
- Removing and installing, refer to BUMPER COVER TRIM, REMOVING AND INSTALLING .
- Cover
- For the towing eye
- Screw
- 1.7 Nm
- Vehicles without a trailer hitch, quantity: 3
- Vehicles with a trailer hitch, quantity: 2
-- Tighten the bolts in the sequence -1 to 3- to 1.5 Nm.
-- Tighten the nuts to 1.5 Nm in the following sequence: -1 and 2-.
-- Tighten the bolts in the sequence -1 to 3- to 1.5 Nm.