Overview - Bumper Cover, Audi A7/S7 From MY 2015
- Bumper Cover Lower Section
- There are different versions.
- Removing and installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING, AUDI RS7 .
- Rear Bumper Cover
- Removing and installing. Refer to BUMPER COVER, REMOVING AND INSTALLING, VEHICLES FROM MY 2015 .
- Bolt
- 2 Nm
- Mount
- For the tail pipe trim
- Removing and installing. Refer to TAIL PIPE TRIM MOUNT, REMOVING AND INSTALLING, FROM MY 2015 .
- Bolt
- 2 Nm
- Quantity: 2
- Bolt
- Quantity: 3
- Tightening sequence, refer to Figure
- Side Mount
- For the bumper cover
- Removing and installing. Refer to BUMPER COVER SIDE MOUNT, REMOVING AND INSTALLING .
- Upper Mount
- For the bumper cover
- Removing and installing. Refer to UPPER BUMPER COVER MOUNT, REMOVING AND INSTALLING .
- Bolt
- Quantity: 3
- Tightening sequence. Refer to Figure
- Locking Rail
- For the bumper cover
- Lane Change Assistance Control Module
- Removing and installing. Refer to LANE CHANGE ASSISTANCE CONTROL MODULES -J769- / -J770- .
- Tail pipe trim
- Removing and installing. Refer to TAIL PIPE TRIM, REMOVING AND INSTALLING, FROM MY 2015 .
- Bolt
- 2 Nm
- Quantity: 3
- Center Mount
- For the bumper cover
- Removing and installing. Refer to CENTER BUMPER COVER MOUNT, REMOVING AND INSTALLING .
- Nut
- Quantity: 2
- Tightening sequence. Refer to Figure
- Bumper Cover Trim
- Removing and installing. Refer to BUMPER COVER TRIM, REMOVING AND INSTALLING .
- Nut
- 2 Nm
- Quantity: 4
- Rear Mount
- For the bumper cover
- Removing and installing. Refer to REAR BUMPER COVER MOUNT, REMOVING AND INSTALLING .
- Nut
- 1.5 Nm
- Quantity: 2
- Adjusting Element
- Cover
- For the towing eye
- Screw
Metal screw
- 1.7 Nm
- Quantity: 2
Bolt M6
- 4.5 Nm
- Quantity: 2