Flywheel And Dual Clutch Overview
NOTE:
All assembly work and tightening specifications are outlined in the "7 speed S-Tronic transmission 0B5, Servicing" repair information.
- Flywheel
- Depending on the vehicle, there are different versions; pay attention to the allocation .
- Removing and installing, refer to Removal and Installation
- Clutch Cover
- There are different versions depending on the date of manufacture, with or without a thrust washer (item: 7)
- Removing and installing, refer to Removal and Installation
- Bolt
- Tightening specification and sequence, refer to Specifications
- O-ring
- Replace
- Dual Clutch
- There are different versions depending on the date of manufacture.
- Removing and installing, refer to REMOVAL AND INSTALLATION
- Always perform the necessary "Guided Functions" on the vehicle diagnostic tester after replacing the dual clutch. Refer to TRANSMISSION GUIDED FUNCTIONS .
- Transmission Housing
- Thrust Washer
- Depending on the date of manufacture, clutch cover allocation
- Ball Bearing
- For the input shaft
- Replacing, refer to Removal and Installation
- Locking Ring
- For ball bearing
- Replace
- Locking Ring
- For the dual clutch
- Replace
- Shaft Seal
- For the input shaft
- Replacing, refer to Removal and Installation
- Bolt
- Tightening specification, refer to Specifications