Fuel Tank, Removing And Installing, Vehicles With Multi-Link Suspension: Installing
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Pay attention to the following:
-- Guide the filler neck between the rear axle and the body.
NOTE:
Disconnect the connector couplings. Refer to CONNECTOR COUPLINGS, SEPARATING .
- Make sure the exhaust system bracket is seated correctly. Refer to EXHAUST SYSTEM, EMISSION CONTROLS , EXHAUST SYSTEM, EMISSION CONTROLS or EXHAUST SYSTEM, EMISSION CONTROLS .
- Be careful to guide the fuel tank filler tube correctly into the opening in the body.
- Make sure vent and fuel lines are not kinked.
- Make sure the supply, return and breather lines are still clipped to the fuel tank after the fuel tank has been installed.
- Position the fuel tank together with the mounting strap on the underbody using Engine and Gearbox Jack VAG 1383A.
- Make sure the line connections are securely fastened.
- Check the fit by pulling on it.
-- Check the ground wires for traces of oxidation on the connectors. Remove any oxidation if necessary.
-- Check the installation position of the ground connection.
- The connector -2- must be securely attached to the metal ring -3-.
- Engage the contact -1- in the fuel tank -4- and secure it with the spacer -5-.
-- Check the connection between the metal ring on the fuel filler neck to an empty area on the body with a ohmmeter.
- Specified value is approximately 0 ohm.
- If the specified values is incorrect, then is a risk of explosion due to discharge of static electricity.