Overview - EVAP System, EVAP Canister In Engine Compartment
WARNING: This page is about a different car, the 2016 Volkswagen Beetle, 2015 Volkswagen Beetle, 2014 Volkswagen Beetle, and 2013 Volkswagen Beetle. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Hose connections are secured with either spring-type or clamp-type clips.
Replace the locking clamps with spring clamps.
Hose Clip Pliers VAS 6340 and the Hose Clip Pliers VAS 6362 is recommended for installing spring-type clips.
The connector couplings must >>audibly<< engage when locking.
Note the color coding when installing the coupling. Refer to CONNECTOR COUPLINGS, SEPARATING !
Pull on the connector coupling to make sure it is secure.
Disconnect the connector couplings. Refer to CONNECTOR COUPLINGS, SEPARATING .
- EVAP Canister
- Component location: in the engine compartment on the right side
- Removing and installing. Refer to EVAP CANISTER, EVAP CANISTER IN ENGINE COMPARTMENT .
- Bracket
- For the EVAP canister
- Nut
- 10 Nm
- Engine Mount
- Bolts
- 10 Nm
- Connecting Line
- With the pressure regulator valve in the connecting line
- Make sure it is secure
- From the fuel tank
- Connecting Line
- To the intake manifold
- Make sure it is secure
- EVAP Canister Purge Regulator Valve 1 -N80-
- The valve is closed when the ignition is off
- Valve is activated (pulsed) by the engine control module when the engine is warm
- Vent Hole