Final Drive, Differential - Rear Final Drive 0BF & 0BE (Coupe)

• Final Drive, Differential
  • General Information
    • Gear Oil In Rear Final Drive 0BF And 0BE, Draining
    • Gear Oil In Rear Final Drive 0BF, Filling
    • Gear Oil In Rear Final Drive 0BE, Filling
    • ATF In Rear Final Drive 0BF And 0BE, Draining
    • ATF In Rear Final Drive 0BF And 0BE, Filling
  • Description And Operation
    • AUDI A4 And AUDI A5
      • Driveshaft Bolted On Transmission-Side Overview
      • Rear Final Drive Overview
    • Driveshaft Mounted On Transmission-Side Overview
    • Electrical And Electronic Components And Component Locations
    • Rear Final Drive Overview
    • ATF And Gear Oil Drain And Inspection Plugs, Rear Final Drive 0BF And 0BE Overview
    • Rear Final Drive, Additional Work After Replacing
      • Notes
      • Tightening Specification
  • Specifications
    • Fastener Tightening Specifications
      • Notes
      • Driveshaft To Rear Final Drive - Tightening Specification And Sequence
      • Driveshaft Heat Shield - Tightening Specification
      • Driveshaft To Rear Final Drive 0BE And 0BF - Tightening Specification And Sequence
  • Diagnosis And Testing
    • Torque Displacement, Checking
    • Gear Oil Level In Rear Final Drive 0BF And 0BE, Checking
    • ATF Level In Rear Final Drive 0BF And 0BE, Checking
  • Removal And Installation
    • AUDI A4 And AUDI A5
      • Driveshaft Bolted On Transmission Side
        • Notes
        • Remove Driveshaft
        • Use The T10172 And T10172/5
        • Install The Driveshaft
        • Removing The Driveshaft
        • Attach The Driveshaft
    • All Wheel Drive (AWD)
      • AWD Control Module
      • AWD Control Module, Additional Work After Replacing
      • Pump
        • Notes
        • Removing
        • Installing
      • Clutch Valve Or Clutch Valve 2
        • Notes
        • Removing
        • Installing
    • Driveshaft, Removing From Rear Final Drive And Installing
      • Notes
      • Remove The Driveshaft From The Rear Final Drive
      • Attach The Driveshaft To The Rear Final Drive
    • Driveshaft Attached On Transmission Side
      • Notes
      • Removing
      • Installing
    • Hydraulic Control Unit
      • Notes
      • Removing
      • Installing
    • Oil Pressure/Temperature Sensor -G437- Or Oil Pressure/Temperature Sensor 2 -G640-
      • Notes
      • Removing
      • Installing
    • Rear Final Drive
      • Notes
      • Removing
      • Installing
    • Flange Shaft Seals, Rear Final Drive Removed
      • Notes
      • Removing
      • Installing
    • Flange Shaft Ring
    • Flange/Driveshaft Seal, Rear Final Drive 0BF
      • Notes
      • Removing
      • Installing
    • Flange/Driveshaft Seal, Rear Final Drive 0BE
      • Notes
      • Removing
      • Installing
    • Flange/Driveshaft Ring
  • Disassembly And Assembly
    • Hydraulic Control Unit
  • Special Tools