Seat Position Sensor, Removing And Installing: Removing
- Follow all safety precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Before handling airbag units (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Fasten the front seat on the Engine/Transmission Holder - Seat Repair Fixture: VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Open the rear wiring holder -1- for modular wire routing on the seat pan lower frame using a screwdriver -arrow- and remove the corrugated tube -2-.
-- Remove the seat position sensor wire -G553- / -G554- from the protective cover -2- and free it up.
-- Remove the bolt -1-.
-- Unclip and disengage the seat position sensor -2- for the lower seat pan -3- -arrow-.
-- Remove the cable ties or cable clips for the wire on the seat pan lower frame.
Driver seat:
-- Disconnect the connector -2- to the seat belt latch.
-- Remove the seat position sensor -1- with the wire -3-.
Front Passenger Seat:
-- Remove the passenger occupant detection system. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .