Passenger Occupant Detection System, Removing And Installing: Installing
Do not disconnect the connectors on the Passenger Occupant Detection System Pressure Sensor -G452- and the Passenger Occupant Detection System Control Module -J706-.
Install in reverse order of removal. Note the following:
- Follow all safety precautions when working with pyrotechnic components (refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS ) and on the passenger occupant detection system (refer to PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION ADDITIONAL SAFETY PRECAUTIONS, MARKET-SPECIFIC ).
- Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
- Do not bend the passenger occupant detection system or the pressure hose.
Make sure the connectors are installed correctly and are secure.
Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.
-- Connect the battery ground cable with the ignition turned on.
When installing a new service kit and after each repair on the front passenger seat where the seat and/or the backrest cover is >>disengaged<<, a basic setting procedure must be performed on the seat occupied recognition control module. Refer to PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION ADDITIONAL SAFETY PRECAUTIONS, MARKET-SPECIFIC . The passenger occupant detection sensor is only installed in the front passenger seat.
-- Select "airbag" in "Guided Fault Finding" to complete. The passenger occupant detection sensor is only installed in the front passenger seat.
- -J706 Passenger Occupant Detection System Control Module, basic setting
If the Airbag Indicator Lamp -K75- signals a fault after installing, check the DTC memory, erase it and check it again.