Component Location Overview - Passenger Occupant Detection System
WARNING:
The replacement part (service kit) for the passenger occupant detection system is already precalibrated and must not be separated under any circumstances. The service kit consists of:
- Passenger Occupant Detection System Control Module -J706-
- Passenger Occupant Detection System Pressure Sensor -G452-
- Passenger Occupant Detection System
- Seat cushion
- Wiring harness between Passenger Occupant Detection System Control Module -J706- and Passenger Occupant Detection System Pressure Sensor -G452- with Front Passenger Seat Position Sensor -G554-.
WARNING:
Follow all safety precautions when working on the passenger occupant detection system. Refer to PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION ADDITIONAL SAFETY PRECAUTIONS, MARKET-SPECIFIC .
NOTE:
The passenger occupant detection system is only installed in the passenger seat.
- Passenger Occupant Detection System Pressure Sensor -G452-
- Unit with cushion, passenger occupant detection system and Passenger Occupant Detection System Control Module -J706- : the components must not be disconnected.
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .CAUTION:
Do not disconnect the electrical connector.
- Seat Pan
- Clip
- Cushion
- For the seat pan
- Unit with passenger occupant detection system, Passenger Occupant Detection System Pressure Sensor -G452- and Passenger Occupant Detection System Control Module -J706- : the components must not be disconnected.
- Clip
- Do not release.
- Passenger Occupant Detection System
- Unit with cushion, Passenger Occupant Detection System Pressure Sensor -G452- and Passenger Occupant Detection System Control Module -J706- : the components must not be disconnected.
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Mount
- For the Passenger Occupant Detection System Control Module -J706-
- Expanding Pin
- For securing the mount to the seat pan
- Wiring Harness
- Must not be disconnected from the Passenger Occupant Detection System Pressure Sensor -G452- and Passenger Occupant Detection System Control Module -J706-.
- Front Passenger Seat Position Sensor -G554-
- Is a component of the electrical wiring harness -9-
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Passenger Occupant Detection System Control Module -J706-
- Unit with passenger occupant detection system, cushion and Passenger Occupant Detection System Pressure Sensor -G452- : the components must not be disconnected.
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .CAUTION:
Do not disconnect the electrical connector.
- Bolt
- 1.5 Nm