Engine Speed Sensor -G28-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the noise insulation. Refer to Noise Insulation, Removing And Installing .

-- Unclip the coolant hose -1- from the charge air pipe and push upward in direction of -arrow-.

Vehicles with Coolant Valve

-- Disconnect the connector -2-.

-- Remove the nuts -arrows- and move the Transmission Coolant Valve -N488- to the side.

All Vehicles

-- Disconnect the connector -1-.

-- Remove the bolt -arrow- and remove the Engine Speed Sensor -G28-.